Test method for 2GHz WCDMA digital cellular mobile communication network user equipment(phase 4)- Part 2:Network compatibility test of high speed packet access(HSPA)
1 Scope
This part specifies methods for additional tests of 2GHz WCDMA digital cellular mobile communication network user equipment (UE) in terms of system access, location area/routing area update, circuit/packet domain cell re-selection, paging, cell update/URA update, handover, circuit/packet domain service, HSDPA, HSUPA, supplementary services, value-added services, concurrent services, call performance, basic functions, etc.
This part is applicable to various types of single-mode WCDMA UE (Phase 4) supporting high speed packet access (HSPA), and dual-mode and multi-mode WCDMA UE.
2 Normative References
The following documents contain provisions which, through reference in this text, constitute provisions of this part. For dated references, subsequent amendments (excluding corrections) to, or revisions, of any of these publications do not apply. However, parties to agreements based on this part are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest editions apply to this part.
YD/T 1548.2-2009 Test Method for 2GHz WCDMA Digital Cellular Mobile Communication Network User Equipment (Phase III)
Part 2: Network Compatibility
3 Abbreviations
For the purpose of this part, the following abbreviations apply.
... ...
... ...
4 General
4.1 Test environment
In this part, the test environment can be divided into two types: commercial network test environment and laboratory test environment. The test items shall be performed in the commercial network test environment as much as possible. Considering the operating security of the commercial network, some test items like those requiring network parameter adjustment and special configuration, can be performed in the test network environment. The recommendations for the test network environment are given in Annex A and the reference test environment is shown in Figure 1.
Temperature: -10℃~35℃
Relative humidity: 0%~95%
Foreword i
Contents iii
1 Scope
2 Normative References
3 Abbreviations
4 General
4.1 Test environment
4.2 UE Information
4.3 Test Implementation
5 System Access
6 Location Area Update
7 Routing Area Update
8 Cell Reselection in Circuit Domain Idle Mode
9 Cell Reselection in Packet Domain Idle Mode
10 Paging
11 Cell Update/URA Update
12 Handover
12.1 General
12.2 Soft/Softer Handover
12.3 Hard handover
13 Circuit domain service
14 Packet Domain Services
15 HSPDA
16 HSUPA
16.1 HSUPA packet data performance test
16.2 Concurrent Service of HSUPA
17 Supplementary Service
18 Value-added Service
19 Concurrent Service
20 Call Performance
21 Additional Test for Basic Function of UE (Optional)
21.1 CS domain attach reject
21.2 PS domain attach reject
21.3 Location Area Update Reject
21.4 Route area update reject
21.5 MM/GMM INFORMATION message
21.6 Change of network name in the MM Information between Different PLMNs
21.7 Change of network name in MM Information between the same PLMNs
21.8 RRC reject redirect
21.9 EPLMN Function
Annex A (Normative) Test Environment Requirements
