Simulation experiment method for air-to-ground missile warhead power index
1 Scope
This standard specifies the general requirements and experiment methods for the simulation experiment for air-to-ground missile warhead power index.
It is applicable to the design, experiment and evaluation of power index simulation of fragment warhead and penetration warhead of air-to-ground missile.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated reference, subsequent amendments (excluding any correction) to, or revisions of, any of these publications do not apply. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the latest editions of the standards indicated below. For undated references, the latest edition applies.
GJB 438A-1997 Defense system software development documentation
3 Terms and definitions
For the purposes of this standard, the following terms and definitions apply.
3.1
fragment warhead
warhead uses the high-energy explosive explosion to drive fragment group at high velocity in order to damage or destroy the target
3.2
fragment warhead power index
index used for measuring the damage or destructive effect fragment warhead, commonly-used power indexes include fragment number and mass distribution, kinetic energy of fragment, specific kinetic energy of fragment, fragment density, and the killing area of warhead
3.3
penetration warhead
warhead used to penetrate into the target or deep subsurface target via large kinetic energy, explodes when penetrating into a certain depth of target in order to damage or destroy the target by the shock wave and stress wave generated in explosion
Foreword i
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
4.1 Experiment item
4.2 Experiment outline
4.3 Experiment equipment
4.4 Experiment plan
4.5 Detailed implementing rule
4.6 Experiment interruption and fault handling
4.7 Safety condition
5 Experiment report
5.1 Mathematical simulation experiment report
5.2 Reports of static explosion simulation experiment and scaled simulation experiment
6 Detailed requirements
6.1 Mathematical simulation experiment for fragment warhead power index
6.2 Static explosion simulation experiment for fragment warhead power index
6.3 Mathematical simulation experiment for penetration warhead power index
6.4 Scaled simulation experiment for penetration warhead power index
