1 Scope
This standard specifies the technical requirements and test methods for WCDMA/GSM (GPRS) dual mode digital mobile user equipment (hereinafter referred to as dual mode digital UE) in terms of service, function, RF performance, Protocol performance, network compatibility and the like.
This standard is applicable to WCDMA/GSM (GPRS) dual mode digital UE.
2 Normative References
The following normative documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated reference, subsequent amendments to (excluding any amendments), or revisions of, any of these publications do not apply. However parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition applies.
YD/T 1214-2006 Technical Requirement of 900/1800MHz TDMA Digital Cellular Mobile Telecommunication Network General Packet Radio Service (GPRS) Equipment: Mobile Stations
YD/T 1215-2006 Testing Methods of 900/1800MHz TDMA Digital Cellular Mobile Telecommunication Network General Packet Radio Service (GPRS) Equipment: Mobile Station
YD/T 1547-2009 Technical Requirements for 2GHz WCDMA Digital Cellular Mobile Communication Network User Equipment (Phase 3)
YD/T 1548.1-2009 Test Method for 2GHz WCDMA Digital Cellular Mobile Communication Network User Equipment (Phase III) - Part 1: Basic Functions, Services and Performance
YD/T 1548.2-2009 Test Method for 2GHz WCDMA Digital Cellular Mobile Communication Network User Equipment (Phase III) - Part 2： Network Compatibility Test
3GPP TS 04.18 Mobile Radio Interface Layer 3 Specification, Radio Resource Control Protocol
3GPPTS 23.122 NAS Functions Related to Mobile Station (MS) in Idle Mode
3GPP TS 25.331 Radio Resource Control (RRC) - Protocol Specification
3GPP TS 34.108 Common Test Environments for User Equipment (UE): Conformance Testing
3GPP TS 34.123-1 User Equipment (UE) Conformance Specification - Part 1: Protocol Conformance Specification
3GPP TS 51.010-1 Digital Cellular Telecommunications System (Phase 2+); Mobile Station (MS) Performance Specification; Part 1: Performance Specification
3 Abbreviations and Symbols
For the purposes of this standard, the following abbreviations and symbols apply.
3.1 Abbreviations
ARPCN Absolute Radio ARFCN Channel Number
BCCH Broadcast Control Channel
BSIC Base Station Identity Code
CFN Connection Frame Number
CPICH Common Pilot Channel
DCCH Dedicated Control Channel
DL Downlink
DRX Discontinuous Reception
DTCH Dedicated Traffic Channel
FDD Frequency Division Duplexing
GPRS General Packet Radio Service
GSM Global System for Mobile communications
HCS Hierarchical Cell Structure
HPLMN Home Public Land Mobile Network
HSUPA High Speed Uplink Packet Access
IE Information Elements
OPLMN Operator controlled PLMN
OCNS Orthogonal Channel Noise Simulator
PCCPCH Primary Common Control Physical Channel
PLMN Public Land Mobile Network
... ...
... ...
3.2 Symbols
EC Average energy per pseudo-noise (PN)
Io Total received power spectral density
Ioc The power spectral density of a band limited white noise source as measured at the UE antenna connector
Ior Total power spectral density of the downlink signal at Node B antenna interface
Îor DownLink received power spectral density
4 General Requirements
UMTS is the third-generation mobile communication system using WCDMA air interface. The entire UMTS system consists of a User Equipment (UE), a Radio Access Network (UTRAN), and a Core Network (CN). The UMTS system is also refered to as WCDMA communication system in this standard.
See YD/T 1214-2006 for the requirements that shall be met for WCDMA/GSM (GPRS) dual mode digital UE operating in GSM mode.
See YD/T 1547-2009 Technical Specification for 2GHz WCDMA Digital Cellular Mobile Communication Network for the requirements that shall be met for WCDMA/GSM (GPRS) dual mode digital UE operating in WCDMA mode.
This standard mainly specifies requirements for dual mode digital UE involving WCDMA/GSM (GPRS) inter-RAT interoperability, radio frequency and protocol performance.
See YD/T 1215-2006 for the test method of dual mode digital UE operating in GSM mode.
As for the test method of dual mode digital UE operating in WCDMA mode, refer to YD/T 1548.1-2009 Test Method for 2GHz WCDMA Digital Cellular Mobile Communication Network User Equipment (Phase III) - Part 1: Basic Functions, Services and Performance and YD/T 1548.2-20094 Test Method for 2GHz WCDMA Digital Cellular Mobile Communication Network User Equipment (Phase III) - Part 2: Network Compatibility Test
This standard mainly specifies the test method of dual mode digital UE involving the interoperability, radio frequency and protocol performance of WCDMA/GSM (GPRS) systems.
5 Technical Requirements
5.1 Service and function requirements
5.1.1 Overview
The contents covered in this section are the basic services and functions that are initiated by and shall be managed / controlled or displayed by the UE. Other services and functions that are initiated or controlled by the network side shall meet relevant requirements specified in Chapters 5, 6, and 7.
Foreword i
1 Scope
2 Normative References
3 Abbreviations and Symbols
4 General Requirements
5 Technical Requirements
6 Service and Function Tests
7 Radio Transmission and Reception Performance Test
8 Protocol Performance Test for WCDMA to GSM
9 Protocol Performance Test from GSM to WCDMA
10 Network Compatibility Test
Bibliography
