This standard specifies the technical requirements, test methods, inspection rules, marking, packing, transportation and storage for the casual.
This standard is applicable to the various general men and women fashion shoes and casual shoes in daily life produced by sticking heat vulcanization method with various natural and synthetic textiles or leather as the major upper materials, with rubber materials as the sole materials.
This standard is not applicable to the children's canvas rubber footwear (shoes) with the shoes sizes less than or equal to 195.
2 Normative References
The following standards contain provisions which, through reference in this text, constitute provisions of this standard. For dated reference, subsequent amendments to (excluding correction to), or revisions of, any of these publications do not apply. However, the parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards. For undated references, the latest edition of the normative document referred to applies.
GB/T 528 Rubber, vulcanized or thermoplastic - Determination of tensile stress-strain properties (eqv ISO 37: 1994)
GB/T 531 Rubber-Determination of indentation hardness by means of pocket hardness meters (idt ISO 7619: 1986)
GB/T 532 Rubber vulcanized or thermoplastic - Determination of adhesion to textile fabric (idt ISO 36: 1993)
GB/T 1689 Rubber vulcanized-Determination of abrasion resistance (Akron machine)
GB/T 2941 Rubber-Standard temperatures, humidities and times for the conditioning environmental and testing of test pieces (eqv ISO 471: 1983)
GB/T 3293.1 Shoes sizes (idt ISO 9407: 1991)
GB/T 3293 Chinese shoe sizing and last systems
HG/T 2198 Rubber vulcanized--The general requirements for the physical test method
HG / T 2403-1992 Test rule, marking, packing, transport, storage for rubber shoes
HG / T 3689 Test method of discoloration for footwear
3 Terms and Definitions
For the purposes of this standard, the following terms and definitions apply.
3.1
Base thickness
The basic thinnest thickness of outsole after deducting the decorative pattern
3.2
Special outsole
It refers to the outsole whose vertical section of the part contacting with the surface is in a nonlinear state and without base thickness, as shown in Figure 1.
