1 Scope
This part specifies test methods of 2GHz WCDMA digital cellular mobile communication network user equipment (UE) in terms of system access, location area/routing area update, cell reselection, paging, cell update/URA update, switchover, circuit domain/packet domain service, HSDPA, supplementary services, value-added services, concurrent services, call performance, etc.
This part is applicable to various types of single-mode UE of 2GHz WCDMA digital cellular mobile communication network, and WCDMA module of dual-mode UE and multi-mode UE.
2 Normative References
The following standards contain provisions which, through reference in this part, constitute provisions of this part. For dated references, subsequent amendments (excluding corrections), or revisions of, any of these publications do not apply to this part. However, parties to agreements based on this part are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies..
YD/T 1547-2009 Technical Requirements for 2GHz WCDMA Digital Cellular Mobile Communication Network User Equipment (Phase 3)
3 Abbreviations
For the purpose of this part, the following abbreviations apply.
AM Acknowledged Mode
AMR Adaptive Multi Rate
AMR-WB Adaptive Multi Rate Wide Band
AuC Authentication Centre
AWGN Additive White Gaussian Noise
BCCH Broadcast Control Channel
BCH Broadcast Channel
CCCH Common Control Channel
CCPCH Common Control Physical Channel
CM Connection Management
CN Core Network
CPCH Common Pilot Channel
CQI Channel Quality Indicator
CRNC Controlling Radio Network Controller
CS Circuit Switched
DL DownLink
DPCH Dedicated Physical Channel
DPCCH Dedicated Physical Control Channel
DPDCH Dedicated Physical Data Channel
DTX Discontinuous Transmission
FACH Forward Access Channel
FPLMN Forbidden Public Land Mobile Network
GMM GPRS Mobility Management
GPRS General Packet Radio Service
GSM Global System for Mobile Communications
HARQ Hybrid Automatic Repeat Request
HPLMN Home Public Land Mobile Network
HSDPA High Speed Downlink Packet Access
HS-DSCH High Speed Downlink Shared Channel
HS-PDSCH High Speed Physical Downlink Shared Channel
HS-SCCH High Speed Shared Control Channel
IMSI International Mobile Subscriber Identity
MAC Medium Access Control
MM Mobility Management
MSC Mobile Switching Centre
NAS Non Access Stratum
P-TMSI Packet TMSI
PDP Packet Data Protocol
PLMN Public Land Mobile Network
RAT Radio Access Technology
RLC Radio Link Control
RPLMN Last Registered PLMN
SCCPCH Secondary Common Control Physical Channel
SRNC Serving Radio Network Controller
TDD Time Division Duplex
4 General
4.1 Test environment
In this part, the test environment can be divided into two types: commercial network test environment and laboratory test environment. In YD/T 1547-2009 Technical Requirements for 2GHz WCDMA Digital Cellular Mobile Communication Network User Equipment (Phase 3), the tests involving network compatibility requirements shall be carried out in a commercial network environment wherever possible, taking into account the operational security of commercial networks. For some test items, if the network parameter adjustment and special configuration are required, it can be carried out in the laboratory environment. See Annex A for details. Reference test environment is as shown in Figure 1.
Foreword i
1 Scope
2 Normative References
3 Abbreviations
4 General
5 System Access
6 Location Area Update
7 Routing Area Update
8 Cell Reselection in Circuit Domain Idle Mode
9 Cell Reselection in Packet Domain Idle Mode
10 Paging
11 Cell Update/URA Update
12 Handoff
13 Circuit Domain Service
14 Packet Domain Services
15 HSDPA
16 Supplementary Services
17 Value-added Services
18 Concurrent Services
Annex A (Informative) Test Environment Recommendations
